Customer Service
Business Hours
Support
+55 (15) 3500-2020
+55 15 3500-2020
vendas@implastec.com.br
Est. Oswaldo Pires de Camargo, 70
Votorantim – São Paulo
No items found.

Isotec - Varnish

Isotec is a varnish designed for protecting and finishing printed circuit boards in electronic assemblies, protecting shafts, and other applications where protection against moisture or other adverse weather conditions and electrical insulation are required.

Request a Quote

Made from a special acrylic resin, it enables the initial and maintenance welding of protected components. It works by forming a thin protective film, which can be adjusted to the desired thickness, as it allows for multiple applications. Its bulk version allows for application by immersion, brush, spray gun, and other methods. When sprayed, the varnish forms a layer with an estimated average thickness of 30 to 40 micrometers.

MAIN APPLICATIONS

Protection, finishing, and insulation of printed circuit boards.

TRANSPORTATION AND STORAGE

Store in the original container in a covered, dry, and well-ventilated area, away from sources of heat or ignition and from oxidizing products, at a maximum temperature of 50°C.

Keep out of reach of children, animals, and people who are unable to handle it.

Aerosol: Do not puncture the can. The gas used as a propellant may be flammable. The disposal of aerosol containers is subject to specific regulations. Keep out of reach of children, animals, and persons who are unable to use the product safely. Do not store the product inside vehicles.

HANDLING AND APPLICATION METHOD

Wear a mask and safety goggles to protect against inhalation of any vapors or splashes. Use in a well-ventilated area.

Aerosol: Hold the can upright, approximately 20 cm away from the application site.

COMMENTS

The information and data contained in this bulletin reflect our current knowledge, as compiled by qualified and reliable technical personnel. It should be considered as guidance and not as a guaranteed specification. In any application, the customer must test performance based on the information we provide. Recommendations for use are not suggestions to infringe on patents or violate laws. Since we have no control over third-party use, our liability is limited solely to our product.

Total curing time: 1 to 3 hours (may vary depending on environmental conditions and the method of application).

‍

‍

Appearance
Base
Conductivity
NLGI Consistency Grade
Color
Colorless
Density
0.900 g/cm³
Packaging
NLGI Grade
Material
Penetration (mm/10)
Drop point
Active Ingredient
Solubility in water